20 × 12 ft L-shaped bed: 6 × 100 ft Fabric Rolls

Selected-roll panel cut plan · lengths in feet
Panel	Direction	Run × span	Strips	Pieces / strip	Tail length	Full + tail rolls
1	lengthwise	20 × 6	1	1	20	0 + 1
2	crosswise	6.50 × 10	2	1	6.50	0 + 1

Roll-size comparison · areas in sq ft; pins at selected spacing
Roll	Cut area	Rolls	Purchased area	Pins
3 × 50 ft	222	2	300	81
3 × 100 ft	222	2	600	81
4 × 50 ft	222	2	400	68
4 × 100 ft	222	2	800	68
6 × 100 ft · selected	198	2	1200	43
6 × 300 ft	198	2	3600	43

Check the footprint and cutting budget

20 × 12 − 10 × 6 = 180 sq ft

The missing corner is split out of the footprint. Two rectangular panels meet with a six-inch overlap; the join has its own pin allowance. The finished perimeter is 64 feet. The cut budget reserves 198 square feet, including 8.25 square feet in overlapping layers and 9.75 square feet trimmed from the footprint. The purchased 2 rolls provide 1200 square feet; 1002 square feet remain as uncut stock.

Read each panel's cuts before buying

Panel 1 runs 20 feet along the strips and 6 feet across them, using the lengthwise direction. The 1 strips cover 6 feet after side overlaps. Each strip uses 1 piece(s): 0 full-length pieces plus a 20-foot tail. One roll supplies 5 complete tails; the panel requires 0 full-piece rolls plus 1 tail-piece rolls. Total full-width cut length is 20 feet. Panels do not share remnants.

Panel 2 runs 6.50 feet along the strips and 10 feet across them, using the crosswise direction. The 2 strips cover 11.50 feet after side overlaps. Each strip uses 1 piece(s): 0 full-length pieces plus a 6.50-foot tail. One roll supplies 15 complete tails; the panel requires 0 full-piece rolls plus 1 tail-piece rolls. Total full-width cut length is 13 feet. Panels do not share remnants.

What changes with a wider overlap?

Changing this exact footprint to twelve-inch overlap produces 2 rolls and 204 square feet of cut fabric, including 17 square feet in overlap. Its trimming allowance becomes 7 square feet. A changed overlap may alter the preferred direction; the program recomputes both rectangular choices.

What changes with closer pins or a fixed direction?

At twelve-inch spacing instead of twenty-four inches, this six-inch-overlap layout reserves 83 pins: 64 around the outside and 19 on seams. With the original spacing and overlap but a forced lengthwise direction, it requires 2 rolls, 240 square feet of cut fabric, and 44 pins. These alternatives keep the same ground dimensions; they change the layout or fastening budget.

Before using this estimate on site

Confirm the actual package dimensions and include any border extensions. Pin counts treat each open seam's endpoints independently, and do not add anchors for plant holes or interior field positions. The roll-size table compares complete cutting plans rather than dividing ground area by package area. Automatic direction checks two directions per panel and does not search every possible patchwork arrangement. Any reduction through offcut reuse requires a separate drawn cut list.

Read the full formulas, assumptions, common mistakes, and FAQs.