24-ft diameter circle: 4 × 100 ft Fabric Rolls

Selected-roll panel cut plan · lengths in feet
Panel	Direction	Run × span	Strips	Pieces / strip	Tail length	Full + tail rolls
1	lengthwise	24 × 24	7	1	24	0 + 2

Roll-size comparison · areas in sq ft; pins at selected spacing
Roll	Cut area	Rolls	Purchased area	Pins
3 × 50 ft	720	5	750	155
3 × 100 ft	720	3	900	155
4 × 50 ft	672	4	800	116
4 × 100 ft · selected	672	2	800	116
6 × 100 ft	720	2	1200	90
6 × 300 ft	720	1	1800	90

Check the footprint and cutting budget

π × 24² ÷ 4 = 452.39 sq ft

The circular footprint is cut from its diameter square. Corner cutoffs are not reused, and seam pins use the square’s full seam lengths. The finished perimeter is 75.40 feet. The cut budget reserves 672 square feet, including 72 square feet in overlapping layers and 147.61 square feet trimmed from the footprint. The purchased 2 rolls provide 800 square feet; 128 square feet remain as uncut stock.

Read each panel's cuts before buying

Panel 1 runs 24 feet along the strips and 24 feet across them, using the lengthwise direction. The 7 strips cover 25 feet after side overlaps. Each strip uses 1 piece(s): 0 full-length pieces plus a 24-foot tail. One roll supplies 4 complete tails; the panel requires 0 full-piece rolls plus 2 tail-piece rolls. Total full-width cut length is 168 feet. Panels do not share remnants.

What changes with a wider overlap?

Changing this exact footprint to twelve-inch overlap produces 2 rolls and 768 square feet of cut fabric, including 168 square feet in overlap. Its trimming allowance becomes 147.61 square feet. A changed overlap may alter the preferred direction; the program recomputes both rectangular choices.

What changes with closer pins or a fixed direction?

At twelve-inch spacing instead of twenty-four inches, this six-inch-overlap layout reserves 226 pins: 76 around the outside and 150 on seams. With the original spacing and overlap but a forced lengthwise direction, it requires 2 rolls, 672 square feet of cut fabric, and 116 pins. These alternatives keep the same ground dimensions; they change the layout or fastening budget.

Before using this estimate on site

Confirm the actual package dimensions and include any border extensions. Pin counts treat each open seam's endpoints independently, and do not add anchors for plant holes or interior field positions. The roll-size table compares complete cutting plans rather than dividing ground area by package area. Automatic direction checks two directions per panel and does not search every possible patchwork arrangement. Any reduction through offcut reuse requires a separate drawn cut list.

Read the full formulas, assumptions, common mistakes, and FAQs.